The RF Summary displays the critical RF transmitter performance measurements in a table format, without demodulating the TD‑SCDMA/HSPA+ signal. The parameters that are displayed in the RF summary table are Channel Power (dBm), Channel Power (RRC) (dBm), Occupied Bandwidth (Hz), DwPTS Power (dBm), UpPTS Power (dBm), On/Off Ratio (dB), Slot PAR (dB), Left Channel Power (dBm), Right Channel Power (dBm), Left Channel Occupied Bandwidth, and Right Channel Occupied Bandwidth.
1. Press the Setup main menu key. (For a few of the setup parameters, you will have the choice of selecting the Auto option in a list box or an Auto submenu key. The Auto submenu key allows you a means of immediate selection rather the scrolling through the list box, highlighting Auto, and pressing the Enter key.)
a. Press the Slot Selection submenu key. The Slot Selection list box and menu open. In the list box, use the Up/Down arrow keys or the rotary knob to highlight Auto or slot 0 through slot 6, and then press the Enter key.
b. Press the Trigger submenu key. The Trigger menu opens.
1. Press the Trigger Type submenu key to toggle through the three trigger types: No Trig, GPS, and Ext. The active state is underlined on the face of the virtual submenu key.
2. Press the Ext Trigger Polarity submenu key to toggle either Rising or Falling trigger edge.
3. Press the Back submenu key to return to the Setup menu.
c. Press the Uplink Switch Point submenu key. The current value on the face of the virtual submenu key turns red and is ready to be edited. Use the Up/Down arrow keys, rotary knob, or numeric keypad to set a new value and press the Enter key.
d. Press the Advanced Settings submenu key to continue with setups under the Advanced Settings menu.
e. Press the Number of Carriers submenu key. The current value on the face of the virtual submenu key turns red and is ready to be edited. Use the Up/Down arrow keys, rotary knob, or numeric keypad to set a new value and press the Enter key.
f. Press the Back submenu key to return to the Setup menu.
2. Press the Measurements main menu key.
3. Press the RF Measurement submenu key.
4. In the RF Measurement menu, press the RF Summary submenu key to view the primary RF measurements in a table.