Cable and Antenna Analyzer Measurement Guide : Cable and Antenna Analyzer : Cable and Antenna Measurement Setup : Display Setup
Display Setup
Single and Dual Display
The instrument can display two measurements simultaneously using the Dual Display function.
Top and Bottom display can be set independently and it is possible to display all measurements either on the top or bottom. Smith Chart is not supported in dual display mode. Markers and Limit Lines can be set for each active display. Both Top and Bottom measurements are saved when saving a measurement in dual display mode. If the Marker Table is turned on in Dual Display Mode, the markers for the active display will show.
Setting Single and Dual Display
1. Press the Measurements main menu key
2. Toggle the Display Format submenu key so that it is set to Dual.
3. Press the Active Display key and set it to Top. This can also be done by touching the upper display directly. The red outline indicates the active display.
4. Select the measurement for the top display.
5. Press the Marker main menu key and turn on the markers for the top display.
6. Open the Limit main menu Shift-6. Turn on the limit line.
7. Press Measurement and toggle Active Display to Bottom and repeat steps 4 to 6 to set the measurements, markers, and limit lines for the bottom display.
Dual Display with the Bottom Display Active