Set Measurement to TD‑LTE Summary

Sets the measurement to TD‑LTE Summary. It disables any other active measurements. None of the instrument parameters are changed by the execution of this command. (:INITiate:CONTinuous OFF). Measurement settings can be modified by using the [:SENSe] commands before initiating a measurement.

SUMMary

<char>

Measurements, TD‑LTE Summary

Configure Query

:CONFigure? query returns the name of the measurement previously set up using a CONFigure command or a MEASure? query. The list below shows the possible return values.

SUMM
RF,SPEC
RF,ACLR
RF,SEM
RF, PVT, SUBF
RF, PVT, FRAM
RF,SUMM
DEM,CONS
DEM,CCPG
DEM,CCPT
DEM,PVRB
DEM,SUMM
PF
OTA,OTAS
OTA,OTATX
OTA,MAP

Select the Modulation Measurement

Sets measurement to one of the Modulation screens. This can be one of:

SUMMary: Modulation Summary view
CONStln: Modulation Constellation diagram
CCPGraph: Control Channel Powers - Bar‑graph view
CCPTable: Control Channel Powers - Table view
TIMEalign: Tx Time Align

It disables any other active measurements. None of the instrument parameters are changed by the execution of this command. Sets the instrument to single sweep mode (:INITiate:CONTinuous OFF). Measurement settings can be modified by using the [:SENSe] commands before initiating a measurement.

SUMMary|CONStln|CCPGraph|CCPTable|TIMEalign

<char>

Measurements, Modulation, (Constellation, Control Channel Power, Tx Time Alignment, Modulation Summary). If Control Channel Power is selected, press Control Channel Power again, then press Display Mode to select Bar Graph or Table.

Configure Over‑the‑Air Measurement

Sets the measurement to one of the Over‑the‑Air screens. This can be one of:

SCANner: Scanner measurement view
TXTEst: Tx Test measurement view
MAPping: Coverage Mapping measurement view
CAGG: Carrier Aggregation view

SCANner|TXTEst|MAPping

<char>

Measurements, Over‑the‑Air, (Scanner, Tx Test, Mapping)

Select RF Measurements

This command configures RF measurements. It disables any other active measurements. None of the instrument parameters are changed by the execution of this command. Sets the instrument to single sweep mode (:INITiate:CONTinuous OFF). Measurement settings can be modified by using the [:SENSe] commands before initiating a measurement.

Set measurement to one of the RF measurement screens. This can be one of:

SUMMary: RF measurement summary screen.
SPECtrum: RF Channel Spectrum measurement screen.
ACLR: ACLR measurement view.
SEM: Spectral Emission Mask measurement.
PVTime: Power vs. Time measurement

SUMMary|SPECtrum|ACLR|SEM|PVTime

Measurements, RF, (Channel Spectrum, Power vs. Time, ACLR, Spectral Emission Mask, RF Summary)

Configure Power vs Time Measurements

Sets the current display mode for Power vs. Time measurements, either ‘Frame’ or ‘Sub‑frame’.

FRAMe|SUBFrame

<char>

Measurements, RF, Power vs. Time, View