Please refer to the User Guide for selecting the TD-SCDMA/HSDPA Signal Analyzer mode, setting up frequency, amplitude, and file management.Channel power measures the average time domain power within the 1.6 MHz channel bandwidth and is expressed in dBm.Channel Power (RRC) is similar to Channel Power but is measured after being filtered by using the Root Raised Cosine (RRC) filter. It is usually smaller than channel power.Occupied bandwidth is the calculated bandwidth containing 99% of the total integrated power occupied in the span. Span is 5 MHz when Number of Carrier is set to 1. For all other values, span is set to 1.6 MHz.The average difference between the active DL slots and the active UL slots, including pilot slots. UL and DL slots are selected according to the Uplink Switch Point setting. Without UL data slot and without UpPTS, the DL-UL Delta Power value is not applicable.The peak to average power in the selected (or auto detected) slot. The highest 0.1% power of the slot is used as the peak.The channel power of the 1.6 MHz channel left of the main channel. This is useful in the multi-carrier environments.The channel power of the 1.6 MHz channel right of the main channel. This is useful in the multi-carrier environments.This is the occupied bandwidth of the channel left of the main channel and is useful in a multi-carrier environment. This value is N/A when Number of Carriers is set to 1.This is the occupied bandwidth of the channel right of the main channel and is useful in a multi-carrier environment. This value is N/A when Number of Carriers is set to 1.Refer to the User Guide for selecting the TD-SCDMA/HSDPA Signal Analyzer mode and continue with the following setups for the specific RF measurements.
| Copyright 2010 Anritsu Company |
|
| Anritsu Company | |
| 1-800-ANRITSU | |
| 10450-00024, Rev. B | |
| mmdtechpubs@anritsu.com |