Error Messages

Introduction

This Appendix provides a list of 3GPP2 error messages. Self Test and General Operation error messages are in the User Guide.

CDMA and EVDO Messages

Warning Messages

“No trigger found”

This message is displayed if the PN trigger is setup for External or GPS, and the software does not detect a trigger. Most measurement results that depend on a trigger are then cleared ('--' is seen in the result area).

“Short Code not found”

This message is displayed if no dominant PN short code is found in the input signal.

Copyright 2010 Anritsu Company
	Anritsu Company
	1-800-ANRITSU
	10450-00024, Rev. B
	mmdtechpubs@anritsu.com