:CONFigure Subsystem

This set of commands prepares the instrument for the selected measurement. It disables any currently-enabled measurements and activates the specified measurement. It sets the instrument to single sweep mode, waiting for an :INITiate command. It will not initiate the taking of a measurement.

Current instrument settings may be changed to default values. These changes are identified with their respective measurement commands.

:CONFigure:DEMod SUMMary|CONStln|CCPGraph|CCPTable

Title

Select the Modulation Measurement

Description

Sets measurement to one of the Modulation screens. This can be one of:

SUMMary: Modulation Summary view

CONStln: Modulation Constellation diagram.

CCPGraph: Control Channel Powers - Bar-graph view.

CCPTable: Control Channel Powers - Table view.

It disables any other active measurements. None of the instrument parameters are changed by the execution of this command. Sets the instrument to single sweep mode (:INITiate:CONTinuous OFF). Measurement settings can be modified by using the [:SENSe] commands before initiating a measurement.

Parameter

SUMMary|CONStln|CCPGraph|CCPTable

Parameter Type

<char>

Front Panel Access

Measurements, Modulation, (Constellation, Control Channel Power, Modulation Summary).

If Control Channel Power is selected, press Control Channel Power again then press Display Mode to select Bar Graph or Table.

:CONFigure:OTA SCANner

Title

Select the Over-the-Air Scanner Measurement

Description

Sets the measurement to one of the Over-the-Air screens.

Measurements, Over-the-Air, Scanner

:CONFigure:RF:PVTime FRAMe|SUBFrame

Title

Configure Power vs Time Measurements

Description

Sets the current display mode for Power vs. Time measurements; either ‘Frame’ or ‘Sub-frame’.

Measurements, RF, Power vs. Time, View

:CONFigure:RF SUMMary|SPECtrum|ACLR|SEM|PVTime

Title

Select RF Measurements

Description

This command configures RF measurements. It disables any other active measurements. None of the instrument parameters are changed by the execution of this command. Sets the instrument to single sweep mode (:INITiate:CONTinuous OFF).Measurement settings can be modified by using the [:SENSe] commands before initiating a measurement.

Set measurement to one of the RF measurement screens. This can be one of:

SUMMary: RF measurement summary screen.

SPECtrum: RF Channel Spectrum measurement screen.

ACLR: ACLR measurement view.

SEM: Spectral Emission Mask measurement.

PVTime: Power vs. Time measurement

Parameter

SUMMary|SPECtrum|ACLR|SEM|PVTime

Front Panel Access

Measurements, RF, (Channel Spectrum, Power vs. Time, ACLR, Spectral Emission Mask, RF Summary)

:CONFigure SUMMary

Title

Set Measurement to TD-LTE Summary

Description

Sets the measurement to TD-LTE Summary. It disables any other active measurements. None of the instrument parameters are changed by the execution of this command. (:INITiate:CONTinuous OFF). Measurement settings can be modified by using the [:SENSe] commands before initiating a measurement.

Measurements, TD-LTE Summary

:CONFigure? query returns the name of the measurement previously set up using a CONFigure command or a MEASure? query. The list below shows the possible return values.

SUMM
RF,SPEC
RF,ACLR
RF,SEM
RF, PVT, SUBF
RF, PVT, FRAM
RF,SUMM
DEM,CONS
DEM,CCPG
DEM,CCPT
DEM,SUMM
PF
OTA,OTAS

Copyright 2010 Anritsu Company
	Anritsu Company
	1-800-ANRITSU
	10450-00024, Rev. B
	mmdtechpubs@anritsu.com