Antenna Setup

The antenna attaches to the instrument with a coaxial cable. The antenna and coaxial cable are not supplied with the instrument and must be procured separately.

The antenna factors are different for each antenna. Refer to the documentation for your antenna. Also, remember to add the cable loss to the measurement correction table. You can use Master Software Tools (MST) to update your antenna and coaxial cable lists. For directions about updating these lists, refer to the Master Software Tools documentation on the MST CD‑ROM that was supplied with your Anritsu instrument.

1.	Attach the antenna to the Spectrum Analyzer connector on top of the instrument (refer to your instrument User Guide).

Select the Antenna as Follows:

2.	Press the Measurements main menu key to open the Meas Selection menu.

3.	Press the RF Measurements submenu key to open the RF Measurements menu.

4.	Press the Signal Power submenu key. The Signal Power submenu key displays a red circle. Press the Signal Power submenu key again to open the Signal Power menu.

5.	Press the Antenna (Correction Level) submenu key to display the Select Antenna list box.

6.	In the Select Antenna list box, scroll to the desired Anritsu antenna model number by using the Up/Down arrow keys or the rotary knob, and press the rotary knob or the Enter key to select the antenna.

 

 

Copyright 2010 Anritsu Company
	Anritsu Company
	1-800-ANRITSU
	10450-00024, Rev. B
	mmdtechpubs@anritsu.com