S331E, S332E, S361E, S362E Site Master™MS2711E, MS2712E, MS2713E Spectrum Master™MT8212E, MT8213E Cell Master™ Programming Manual : All Mode Commands : :CONFigure Subsystem
 
:CONFigure Subsystem
This set of commands prepares the instrument for the selected measurement. It disables any currently-enabled measurements and activates the specified measurement. It sets the instrument to single sweep mode, waiting for an :INITiate command. It will not initiate the taking of a measurement.
Current instrument settings may be changed to default values. These changes are identified with their respective measurement commands.
Note 
In dual display mode, the top and bottom channels CANNOT be the same measurement type.
:CONFigure:MEASure?
Title
Current Active Measurement Mode
Description
Reports the current active measurement mode.
Front Panel Access
Measurements (Active measurement is indicated by the red radial button.)
:CONFigure:MEASure:1PHase
Title:
Configure 1-Port Phase Measurement
Description:
Changes the current measurement to 1-Port Phase.
Related Command:
:CONFigure:MEASure:?
Front Panel Access:
Shift‑4 (Measure), More, 1-Port Phase
:CONFigure:MEASure:ACTiveChan 0|1
:CONFigure:MEASure:ACTiveChan?
Title:
Active Channel 0/1
Description:
Toggles between channel 0 (top) and 1 (bottom). Only functional in Dual Display Mode.
Front Panel Access:
Measurements (Active measurement is indicated by the red radial button.)
:CONFigure:MEASure:CABLoss
Title:
Configure Cable Loss
Description:
Changes the current measurement to Cable Loss.
Related Command:
:CONFigure:MEASure:?
Front Panel Access:
Shift‑4 (Measure), Cable Loss
:CONFigure:MEASure:DUALdisplay DUAL|SINGLE
:CONFigure:MEASure:DUALdisplay?
Title:
Dual Display On/Off
Description:
Turns dual display on or off.
Front Panel Access:
Measurements, Display Format
:CONFigure:MEASure:RLDTf
Title:
Configure DTF Return Loss
Description:
Changes the Cable & Antenna measurement to DTF Return Loss.
Related Command:
:CONFigure:MEASure:?
Front Panel Access:
Shift‑4 (Measure), DTF Return Loss
:CONFigure:MEASure:RLFReq
Title:
Configure Return Loss
Description:
Changes the current measurement to Return Loss.
Related Command:
CONFigure:MEASure:?
Front Panel Access:
Shift‑4 (Measure), Return Loss
:CONFigure:MEASure:SMCHart
Title:
Configure Smith Chart
Description:
Changes the current measurement to Smith Chart.
Related Command:
:CONFigure:MEASure:?
Front Panel Access:
Shift‑4 (Measure), More, Smith Chart
:CONFigure:MEASure:SWRDtf
Title:
Configure DTF VSWR
Description:
Changes the current measurement to DTF VSWR.
Related Command:
:CONFigure:MEASure:?
Front Panel Access:
Shift‑4 (Measure), DTF VSWR
:CONFigure:MEASure:SWRFreq
Title:
Configure Standing Wave Ratio (SWR)
Description:
Changes the current measurement to SWR.
Related Command:
:CONFigure:MEASure:?
Front Panel Access:
Shift‑4 (Measure), SWR