Configure Query

:CONFigure? query returns the name of the measurement previously set up using a CONFigure command or a MEASure? query. The list below shows the possible return values.

CAGG
SUMM
RF,SPEC
RF,ACLR
RF,SEM
RF,SUMM
DEM,CONS
DEM,CCPG
DEM,CCPT
DEM,SUMM
PF
OTA
OTA,OTAS

Select the Modulation Measurement

Sets measurement to one of the Modulation screens. This can be one of:

SUMMary: Modulation Summary view
CONStln: Modulation Constellation diagram
CCPGraph: Control Channel Power ‑ Bar‑graph view
CCPTable: Control Channel Power - Table view
TIMEalign: Tx Time Alignment

It disables any other active measurements. None of the instrument parameters are changed by the execution of this command. Sets the instrument to single sweep mode (:INITiate:CONTinuous OFF). Measurement settings can be modified by using the [:SENSe] commands before initiating a measurement.

SUMMary|CONStln|CCPGraph|CCPTable|TIMEalign

<char>

Measurements, Modulation, (Constellation, Control Channel Power, Tx Time Alignment, Modulation Summary). If Control Channel Power is selected, press Control Channel Power again, then press Display Mode to select Bar Graph or Table.

Configure Over‑the‑Air Measurement

Sets the measurement to one of the Over‑the‑Air screens. This can be one of:

SCANner: Scanner measurement view
TXTEst: Tx Test measurement view
MAPping: Coverage Mapping measurement view
CAGGregation: Carrier Aggregation measurement view

SCANner|TXTEst|MAPping|CAGGregation

<char>

Measurements, Over‑the‑Air, (Scanner, Tx Test, Mapping, Carrier Aggregation)

Select RF Measurements

This command configures RF measurements. It disables any other active measurements. None of the instrument parameters are changed by the execution of this command. Sets the instrument to single sweep mode (:INITiate:CONTinuous OFF).Measurement settings can be modified by using the [:SENSe] commands before initiating a measurement.

Set measurement to one of the RF measurement screens. This can be one of:

SUMMary: RF measurement summary screen.

SPECtrum: RF Channel Spectrum measurement screen.

ACLR: ACLR measurement view.

SEM: Spectral Emission Mask measurement.

SUMMary|SPECtrum|ACLR|SEM

Measurements, RF, (Channel Spectrum, ACLR, Spectral Emission Mask, RF Summary)

Set Measurement to Carrier Aggregation

Sets the measurement to Carrier Aggregation.

CAGGregation

None

Configure Over‑the‑Air Measurement

Sets the measurement to one of the Over‑the‑Air screens.

SCANner|TXTEst|MAPping|CAGGregation

<char>

Set Measurement to LTE Summary

Sets the measurement to LTE Summary. It disables any other active measurements. None of the instrument parameters are changed by the execution of this command. (:INITiate:CONTinuous OFF). Measurement settings can be modified by using the [:SENSe] commands before initiating a measurement.

SUMMary

<char>

Measurements, LTE Summary