VNA Masterâ„¢Programming Manual : VNA Commands : [:SENSe]:RFON[:STATe] Subsystem
 
[:SENSe]:RFON[:STATe] Subsystem
This subsystem sets the state of the RF output signal at the VNA ports.
RF Power In Hold State
[:SENSe]:RFON[:STATe]
Description
Sets the state of the RF output signal at the VNA ports to be either ON or OFF when the sweep is set to Hold. When set to ON, the RF signal continues to be energized when the sweep is in hold. When set to OFF, the RF signal is turned off during the hold condition. Note that if the RF has been turned OFF during hold, then the sweep may require more time to stabilize when it is set to run.
Syntax
[:SENSe]:RFON[:STATe] ON|OFF|1|0
Cmd Parameter
<boolean> ON|OFF|1|0
Query Response
<bNR1> 1|0
Default Value
ON
Related Command
[:SENSe]:SWEep:TYPE
:INITiate:HOLD
Front Panel Access
Shift 3 (Sweep), RF Pwr in Hold