The Mass Memory Load subsystem contains commands to transfer from the mass memory device to the internal memory.
Note
Recall and Save for both setup and measurement, as described in this section, are specific for vector network analyzer modes, not for spectrum analyzer mode.
Recall Setup
:MMEMory:LOAD:STATe
Description
No query. Recalls a previously stored setup from the current save location. The saved setup that is to be loaded is specified by <filename>. <filename> must be enclosed in either single quotes (‘ ’) or double quotes (“ ”) and must include the extension “.stp”. The <integer> parameter is not currently used, but it must be sent. Send a value of 1.
Note
When recalling a setup that causes a mode switch, wait a minimum of 60 seconds before issuing the next command.
Syntax
:MMEMory:LOAD:STATe <integer>,<filename>
Cmd Parameter
<integer>,<string> (1, file name)
Cmd Parameter
NA (no query)
Related Command
:MMEMory:STORe:STATe :MMEMory:MSIS INTernal|USB
Front Panel Access
Shift‑7 (File), Recall, Change Type (select file type from list)
Recall Measurement
:MMEMory:LOAD:TRACe
Description
Recalls a previously stored measurement trace from the current save location. The saved measurement trace that is to be loaded is specified by <filename>. <filename> must be enclosed in either single quotes (‘ ’) or double quotes (“ ”) and must contain a file extension of “.mna”. Note that the trace that is specified by <filename> must be available at the current save location. Note that existing files of the same name will not be overwritten. The <integer> parameter is not currently in use, but it must be sent. Send a 1. File Extensions: “.mna”.
Syntax
:MMEMory:LOAD:TRACe <integer>,<filename>
Cmd Parameter
<integer>,<string> (1, file name)
Query Response
NA (no query)
Example
To recall trace with file name “trace”:
:MMEMory:LOAD:TRACe 1,“trace.mna”
Related Command
:MMEMory:STORe:TRACe :MMEMory:MSIS INTernal|USB
Front Panel Access
Shift‑7 (File), Recall, Change Type (select file type from list)