General Information

Introduction

Selecting Tracking Generator Option

Selecting Vector Signal Generator Mode

Introduction

This Measurement Guide documents the Tracking Generator (Option 0020) and the Vector Signal Generator (Option 0023). Check the user guide for your Anritsu handheld instrument to find which options are available. An available option must be installed in your instrument before it can be used.

Selecting Tracking Generator Option

If the Tracking Generator option is installed in your instrument, then in the Spectrum Analyzer mode, a Tracking Generator submenu key is available in the Measure 2/2 menu. Refer to Figure: Measure Menu with Tracking Generator (Option 20).

1.	Press the Shift key followed by pressing the Measure (4) key on the numeric keypad to open the Measure menu.

2.	Press the More submenu key to open the Measure 2/2 menu.

3.	Press the Tracking Generator submenu key to open the Tracking Generator menu.

Selecting Vector Signal Generator Mode

1.	Press the Shift key followed by pressing the Mode (9) key on the numeric keypad to open the Mode Selector list box.

2.	Use the directional arrow keys or the rotary knob to highlight the Vector Signal Generator mode, then press the Enter key to select.

 

Caution

The maximum input power without damage is + 30 dBm on the RF In port. To prevent damage, always use a coupler or high power attenuator.

 

 

 

Copyright 2011 Anritsu Company
	Anritsu Company
	1800-ANRITSU
	10450-00034, Rev. A
	mmdtechpubs@anritsu.com