Error Messages

Introduction

This chapter provides a list of information and error messages that could be displayed on your instrument. If any error condition persists, contact your local Anritsu Service Center (http://www.anritsu.com/Contact.asp).

This Appendix provides a list of Interference Analyzer and Channel Scanner messages. Self Test and General Operation error messages are in Appendix A of the User Guide.

Interference Analyzer Error Messages

•	Trace not saved. Please wait for complete sweep and try again.

•	Measurement has been turned OFF

•	Measurement not valid in Zero Span

•	Measurements can not be displayed in Full Screen mode

•	The Freq range of the Antenna is invalid for this setup. Please select another Antenna

•	DDC Failure

•	Lock failed during initialization

•	Invalid Attenuation for PreAmp Setting

•	Unable to add additional limit points. %d is the maximum.

•	Hidden inflection points prevent this action. Decrease Span to reveal hidden points.

•	Trace A has no data to view

•	Trace B has no data to view

•	Trace C has no data to view

•	Turning off Trace Overlay

•	Only HOLD is valid for Trace C when trace C is not being updated from A

•	Auto Save not available when Time Span is Auto

•	The specified Time span is too big to save all measurements. Automatically adjusted Time

•	Span to a valid number

•	DSP Memory Failure

•	Pretune Calibration Failure

•	Lock failure %x

•	Locking to Internal Ref failed

•	Locking to External Ref failed

•	Lock attempt Failed

•	Timed Measurement Done. Press Reset/Restart Meas to continue measuring

•	Current measurement is stopped when Cursor is not zero

•	OVER POWER ERROR

•	Fatal error, Unknown

•	Fatal error, EEPROM failed

•	Fatal error, no IA board connected

•	Fatal error not decoded by DSP

•	UNKNOWN ERROR In IA

•	Operation not Permitted in Recall Mode

•	Operation not Permitted in this Mode

•	Marker must be ON to Use the feature

•	Triggering valid only in Zero Span

•	Only HOLD is valid for Trace B

•	Cannot change average for Recalled/Inactive Traces

•	Cannot set Delta Mkr Freq to Demod Freq

Channel Scanner Error Messages

•	Error Recalling Measurement

•	Not Available when Max Hold is OFF

•	Operation not Permitted in Recall Mode

•	ADC Over range: Increase Reference Level

•	Mixer Saturation: Increase Attenuation

Copyright 2011 Anritsu Company
	Anritsu Company
	1800-ANRITSU
	10450-00034, Rev. A
	mmdtechpubs@anritsu.com