1. Change the instrument measurement mode (if required). Press Shift then Mode (9).
2. Select the measurement type. Press Shift then Measure (4). Select the appropriate measurement type with the submenu key.
Saving Measurements
1. Press the Save Measurement submenu key.
2. Press the Change Save Location submenu key and set the current location to be the USB flash drive or internal memory, and then press Set Location.
3. Press Change Type (Setup/JPG/…) and select Measurement. Then press the JPEG Capture submenu key (to select Full or Graph Only), if desired. Then press Enter.
4. Enter the file name using the touch keyboard and press Enter (touch screen or hard key).
Note
After the Save Location and File Type are changed, these settings will remain in effect until manually changed again.
Refer to File Management for additional file management information.