1. Change the measurement mode (if required). Press Shift then Mode (9). Use the directional arrow keys, rotary knob, or touch screen to highlight the selection, and press the Enter key to select.
2. Select the measurement type. Press Shift then Measure (4). Select the appropriate measurement type with the submenu key.
Saving Measurements
1. Press Shift then File (7).
2. Press the Save Measurement submenu key.
3. Press the Change Save Location submenu key and set the current location to be the USB flash drive or internal memory. Then press Set Location.
4. Press Change Type (Setup/JPEG/…) and select Measurement.
5. Enter the file name using the letter key and press Enter.
Refer to File Management for additional information. The Save on Event submenu key is described in the File Menu.
Anritsu PC Software Tools
Anritsu Master Software Tools and Line Sweep Tools are Microsoft Windows compatible programs for transferring and editing saved measurements, markers, and limit lines to a PC. Refer to Anritsu Tool Box for an overview of the software.
External Power On
The When DC Applied setting in the Power‑On menu allows the BTS Master to restart automatically when external DC power is applied to the connector.
When this feature is enabled, the BTS Master in the off state will turn on when external DC power is applied. The instrument turns off when external power is removed, even if a battery is installed. This is useful for high-reliability remote operation, where the instrument may need to be rebooted using a remotely-controlled power switch.
If the instrument is turned on with the power switch, then external power is removed, the instrument will continue to run until the battery is depleted. It will come on and the battery will begin recharging when external power is applied. This state is useful when the instrument is in a location where the power source may be interrupted.