PIM Master™ Passive Intermodulation Analyzer with Site Master™ Cable & Antenna Analyzer Option Programming Manual : Cable & Antenna Commands : :CONFigure Subsystem
 
:CONFigure Subsystem
This set of commands prepares the instrument for the selected measurement. It disables any currently-enabled measurements and activates the specified measurement. It sets the instrument to single sweep mode, waiting for an :INITiate command. It will not initiate the taking of a measurement.
Current instrument settings may be changed to default values. These changes are identified with their respective measurement commands.
Note 
In dual display mode, the top and bottom channels CANNOT be the same measurement type.
:CONFigure:MEASure?
Title
Current Active Measurement Mode
Description
Reports the current active measurement mode.
Front Panel Access
Measurements (Active measurement is indicated by the red radial button.)
:CONFigure:MEASure:ACTiveChan 0|1
:CONFigure:MEASure:ACTiveChan?
Title:
Active Channel 0/1
Description:
Toggles between channel 0 (top) and 1 (bottom). Only functional in Dual Display Mode.
Front Panel Access:
Measurements (Active measurement is indicated by the red radial button.)
:CONFigure:MEASure:DUALdisplay DUAL|SINGLE
:CONFigure:MEASure:DUALdisplay?
Title:
Dual Display On/Off
Description:
Turns dual display on or off.
Front Panel Access:
Measurements, Display Format
:CONFigure:MEASure:RLDTf
Title:
Configure DTF Return Loss
Description:
Changes the Cable & Antenna measurement to DTF Return Loss.
Front Panel Access:
Shift‑4 (Measure), DTF Return Loss
:CONFigure:MEASure:RLFReq
Title:
Configure Return Loss
Description:
Changes the current measurement to Return Loss.
Front Panel Access:
Shift‑4 (Measure), Return Loss
:CONFigure:MEASure:1PHase
Title:
Configure 1-Port Phase Measurement
Description:
Changes the current measurement to 1-Port Phase.
Front Panel Access:
Shift‑4 (Measure), More, 1-Port Phase
:CONFigure:MEASure:SMCHart
Title:
Configure Smith Chart
Description:
Changes the measurement to Smith Chart.
Front Panel Access:
Shift‑4 (Measure), More, Smith Chart
:CONFigure:MEASure:SWRDtf
Title:
Configure DTF VSWR
Description:
Changes the measurement to DTF VSWR.
Front Panel Access:
Shift‑4 (Measure), DTF VSWR