The coaxial setup dialog for SOLT (and SOLR), full 2-Port calibration is shown in below.

In the coaxial setup dialog, the connector types for both ports are selected as well as the through details and the type of load to be used. For one port calibrations, only one of the port definitions (unless reflection-only calibrations are being performed for both ports 1 and 2) will be present. For a 1 path-2 port cal, one of the Test Port definition sections will not be shown.

The setup dialog above is for coaxial and non-dispersive line types. For waveguide and microstrip, a few things change:

A waveguide SOLT setup is shown in Figure: TWO PORT CAL SETUP (SOLT/R, WAVEGUIDE) Dialog Box and a setup for microstrip is shown in Figure: TWO PORT CAL SETUP (SOLT/R, MICROSTRIP) Dialog Box.

The standards information dialog for SOLT (and SOLR) is shown in Figure: STANDARD INFO (SOLT/R) - V-Connectors (M), using a V-connector as an example.

For cal kits loaded from Anritsu cal kit files, the model terms are not editable. When using user-defined cal kits, the model terms can be edited.

The standards information for microstrip does not change but the microstrip media information must be either user-defined (Figure: USER-DEFINED MICROSTRIP Data Input Dialog Box) or selected from an Anritsu microstrip cal kit (Figure: MICROSTRIP INFO 10 Mil Kit Dialog Box, typically used with Anritsu Universal Test Fixtures).

Effective dielectric constants can be entered, or the recommended value can be selected.

For waveguide, the model parameters and the media parameters are combined in one dialog (Figure: USER-DEFINED WAVEGUIDE (SOLT/R) Information Dialog Box).