The appearance and button availability of the calibration menus depends on the settings established in the CAL SETUP, CAL METHOD, LINE TYPE menus and in the associated dialog boxes that appear from the Edit Cal Params button.
Full Name
• Transmission Frequency Response Calibration
Menu Name
• TRANS. RESPONSE
Button Name
• Transmission Freq. Response
TRANS. RESPONSE Menu - 2-Port VNAs
Full Name
• TRANSMISSION FREQUENCY RESPONSE CALIBRATION SETUP Menu
The exact composition of the menu depends on the settings made on the CAL SETUP, CAL METHOD, and LINE TYPE menus and on the resultant TRANSMISSION FREQUENCY REPONSE CAL SETUP dialog box. A representative menu is shown below. There is one example procedure of a TRANS. RESPONSE calibration in this chapter.
• MAIN | Calibration | CALIBRATION | Calibrate | CALIBRATE | Manual Cal | MANUAL CAL | Transmission Freq. Response | TRANS. RESPONSE
TRANS. RESPONSE Menu - Trans. Freq. Resp. Cal. - 2-Port VNAs - Typical example
Modify Cal Setup
Select displays the CAL SETUP menu where the Edit Cal Params button provides access to the TRANSMISSION FREQUENCY RESPONSE CAL SETUP dialog box for the selected calibration method and line type.
Read-only display of the ports selected for the pending calibration.
Completion Menu Buttons
For this example menu, the Thru/Recip and Isolation (Optional) buttons link to completion submenus where additional calibration procedures are performed.
For example, the Thru/Recip button (shown below at #1) links to the THRU/RECIP submenu. As each procedure is completed, the submenu button is marked with a completion checkmark. When all the procedures on the submenu are completed, use the Back button to return to the TRANS. RESPONSE menu.
The Thru/Recip button (shown above at #2) is now marked with a completion checkmark.
Thru/Recip
When selected, displays the THRU/RECIP menu. When all tasks are complete, return to the TRANS. RESPONSE menu.
Isolation (Optional)
When selected, displays the ISOLATION menu. When all tasks are completed, return to the TRANS. RESPONSE menu.
Done
This button is unavailable until all calibration tasks have been successfully completed. When available, select the button to return to the CALIBRATION menu when the Cal Status is set to ON.
• MAIN | Calibration | CALIBRATION | Calibrate | CALIBRATE | Manual Cal | MANUAL CAL | Transmission Freq Response | TRANS FREQ (TRANSMISSION FREQUENCY RESPONSE) | Modify Cal Setup | CAL SETUP | Edit Cal Params | TRANSMISSION FREQUENCY RESPONSE CAL SETUP (SOLT/R, COAXIAL) Dialog Box
TRANS. FREQ. RESP. CAL. SETUP (SOLT/R, COAXIAL) Dialog Box
TRANSMISSION FREQUENCY RESPONSE CALIBRATION SETUP Dialog Box
Select Direction And Ports
Select any combination of the two available throughs. At least one thru must be selected. Both the Thru Port 1 to Port 2 and the Thru Port 2 to Port 1 may be selected.
Thru 1-2 Info Button
Select the Thru 1-2 to display the THRU INFO dialog box.
• Any numerical value accepted although input values <0.01 Ohms are converted to 0.01 Ohms.
Transmission Frequency Response Calibration Setup Dialog Boxes
The table below summarizes the available fields and controls in other transmission frequency response calibration setup dialog boxes (abbreviated in this section as Trans. Freq. Resp. Cal.). To view each dialog box, set the CAL METHOD and LINE TYPE menus to the appropriate settings, and then select the Edit Cal Params button.
