Spectrum Analyzerfor Anritsu RF and Microwave Handheld Instruments : Interference Analyzer (Option 25) : Measurements Menu : IQ Waveform Capture Menu (Option 24)
  
IQ Waveform Capture Menu (Option 24)
Key Sequence: Measurements > Spectrum > IQ Waveform Capture
IA IQ Waveform Capture Menu
 
Start Capture
Initiates a capture using the current settings. Messages will appear on screen to notify the user of progress and the filename of the data acquired after the waveform capture is complete (Figure: IQ Waveform Capture). If Capture Mode is set to Continuous, this button becomes the Stop Capture button. Press the Stop Capture button to end a continuous waveform capture.
Capture Length
Sets the time length of the capture.
Capture Mode
When set to “single”, the unit will perform 1 waveform capture each time “Start Capture” is pressed. When set to “continuous”, the instrument will begin a new capture as soon as the previous one is finished.
Sample Rate
Opens the Select Capture Sample Rate dialog (Figure: IQ Capture Sample Rate). Select the desired Sample Rate (MHz) and associated Bandwidth (MHz) and then press Enter.
Triggering
Opens the IQ Capture Triggering Menu to set the triggering parameters.
File Name & Location
Opens the IQ Capture Save Menu to set the directory location of the saved file and the prefix of the file name.
Frequency/Amplitude
Opens the IQ Capture Frequency/Amplitude Menu which contains the specific buttons for setting up the capture waveform frequency, display and attenuation parameters.
 
Back
Returns to the [Spectrum] Measure Menu.
This menu and its submenu key within the Measure menu are displayed only when Option 24 is installed on your instrument.