 | Display 1 LTE BW This is the LTE carrier bandwidth for Display 1. Press this key to display the Select Bandwidth list box illustrated in Figure: Select LTE Bandwidth. Use the touch screen, arrow keys, or rotary knob to highlight the LTE carrier bandwidth, then press Enter. Selectable values are 5 MHz, 10 MHz, 15 MHz, and 20 MHz. If the bandwidth (such as 10 MHz) is displayed in red on the menu key label, you can use the arrow keys or rotary knob to change the value, then press Enter. Display 2 LTE BW This key is active only in dual display mode. Press the key to open the Select Bandwidth list box illustrated in Figure: Select LTE Bandwidth. Use the touch screen, arrow keys, or rotary knob to highlight the LTE carrier bandwidth for Display 2, then press Enter. Selectable values are 5 MHz, 10 MHz, 15 MHz, and 20 MHz. Display Mode Single Dual Press this key to toggle between single and dual display mode. Up to four traces can be displayed on a single display, or they may be distributed between the two displays in dual display mode, as illustrated in Figure: Spectrum Dual Display. When switching from dual to single mode, the currently active display, as selected by the Active Display key described below, will be shown as the single display. Active Display 1 2 This key is active only in dual display mode. Press the key to toggle between Display 1 and 2. The currently active display is highlighted with a red border. See Figure: Spectrum Dual Display. Settings under the following menus apply to the active display only: Frequency Amplitude Bandwidth Limit Back Returns to the OBSAI Config Menu. |
