Spectrum Analyzer Measurement Guide : Interference Analyzer (Option 25) : Interference Mapping : Save the Mapping Information
 
Save the Mapping Information
There are three save options in Interference Mapping.
Save JPG
Press Save/Recall Points/Map then Save JPG. At the Save menu, press Enter. A .jpg file of the current screen will be saved.
The JPG file can be viewed on a PC.
Displaying a Saved JPG File on a PC
Save KML Points
Press Save/Recall Points/Map then Save KML Points. At the Save menu, select KML 2D or KML 3D, then press Enter. The following information is saved for the points and vectors currently displayed on the screen:
Signal strength (dBm)
Bearing
Setup (frequency, RBW, VBW, and detection type)
Current location
The .kml file can be opened and viewed on a PC with Google Earth (http://earth.google.com/) and also recalled and viewed on the instrument (Figure: KML File on the PC and the Anritsu Instrument). Refer to Mapping Save/Recall Menu for additional information.
KML File on the PC and the Anritsu Instrument
 
Note 
To delete existing bearings before recalling a map, refer to Bearing Lines Menu.
Save Tab Delimited Points
Press Save/Recall Points/Map then Save Tab Delimited Points. At the Save menu, press Enter. A tab delimited text file (.mtd) will be saved to the current location for the points and vectors currently displayed on the screen.
The Mapping Tab Delimited (.mtd) file can be viewed on a PC in a text editor or excel (Figure: MTD File Opened in Excel).
MTD File Opened in Excel
Information for each point includes location, time, signal strength, bearing, and instrument setup data. If you do indoor coverage mapping (or any non-geo-referenced mapping), the .mtd file is saved with the Latitude and Longitude columns in display points (screen display pixels). The upper left corner is 0,0 and the lower right corner is 665, 419. Refer to Coverage Mapping (Option 431) for more information.