Scanner: Press this submenu key to display the Scanner table, which shows several power measurements for multiple base stations at the same frequency. Measurements include Sync Signal (S-SS) Power, RSRP, RSRQ, and SINR. Press the key again to display the OTA Scanner Menu to set up Sort By and Show Mod Results.

Tx Test: Opens the OTA Tx Test mode. Press it again to open the Over‑the‑Air Tx Test Menu and the Show Mod Results submenu key.

Mapping: Sets the display for coverage mapping. Press it again to set the coverage mapping parameters – Save/Recall Points/Map, Measurement Setup and Point Distance/Time Setup.

For full details, refer to LTE and TD‑LTE Coverage Mapping.

Carrier Aggregation: Press this submenu key to display the Carrier Aggregation Component Carrier frequencies and measured parameters. In the Carrier Aggregation Menu, select the desired Component Carrier to set up for measurement. Refer to Carrier Aggregation Menu.

EMF (Option 444 only): When first selected, this submenu key enables the EMF Measurement mode. See EMF Measurements (Option 444) for more information.

eMBMS: When selected, this submenu key enables the OTA eMBMS Test Measurement mode. Once this mode is active, the display area indicates the Cell ID and the RSRP (Reference Signal Received Power). Note that eMBMS information may require several frame captures and each capture can take several seconds to analyze. NA will be displayed until a valid measurement is achieved.

Back: Press this submenu key to return to the Measurements Menu.