Basic Measurement Setups

Introduction

Measurement Setup

Connect the Input Source

Editing and Entering Values

Selecting the Analyzer Mode

Set the Measurement Frequency

Using Start and Stop Frequencies

Entering Center Frequency

Selecting Signal Standard

Setting Measurement Frequency Bandwidth

Set the Amplitude

Setting Amplitude Reference Level and Scale

Setting Amplitude Range and Scale

Power Offset Set Up for Compensating External Loss

Set the Span

Setting Up Limit Lines

Single Limit Line

Segmented Limit Lines

Limit Line Envelope

Setting Up Markers

Selecting, Activating, and Placing a Marker

Selecting, Activating, and Placing a Delta Marker:

Viewing Marker Data in a Table Format

Introduction

This chapter provides a brief overview of the Anritsu MT8222A BTS Master. The intent of this chapter is to provide a starting point for making basic measurement setups. This chapter describes setup, configure frequency, bandwidth, and amplitude before configuring your measurement setups. After measurements are taken, refer to section “Managing Files” for a description of saving, recalling, and deleting measurement files. For more detailed information about specific measurements, refer to the measurement descriptions in the measurement guides for the specific instrument mode and analyzer technology (such as WiMAX or 3GPP). Refer to “Measurement Guides”, for a list of these guides and their Anritsu part numbers.

Copyright 2010 Anritsu Company
	Anritsu Company
	1-800-ANRITSU
	10450-00024, Rev. B
	mmdtechpubs@anritsu.com