Measurement Setup

Connect the Input Source

Connect the input signal or antenna to the appropriate test connector on the top of the instrument. For connector descriptions, refer to Figure: “Test Panel Connectors, including T1 and T3”.

Editing and Entering Values

•	Parameter values that are ready for editing are displayed in red on the submenu key. After changing the value, press Enter to set the new value.

•	Some submenu keys have toggled parameter values (On / Off, Low / High). On these submenu keys the current value is underlined. Press the submenu key to toggle the value.

•	Use the arrow keys, numeric keypad, or rotary knob to change submenu key values, to select list box options, or to enter filenames.

Selecting the Analyzer Mode

1.	Press the Shift key followed by pressing the Mode (9) key on the numeric keypad to open the Mode Selector list box.

2.	Use the directional arrow keys or the rotary knob to highlight the desired mode, and press the Enter key or the rotary knob to select.

 

Copyright 2010 Anritsu Company
	Anritsu Company
	1-800-ANRITSU
	10450-00024, Rev. B
	mmdtechpubs@anritsu.com