:CONFigure Subsystem

This set of commands prepares the PIM instrument hardware for the selected measurement. It activates the specified measurement and sets the instrument to a wait‑for‑sweep mode, waiting for an :INITiate command. It will not initiate the taking of a measurement.

:CONFigure:PIManalyzer:SETup

Title

Configure PIM Master Hardware for Measurement

Description

Creates and sends a defined configuration to the PIM Master based on the previously set SCPI command configuration parameters.

Note	This command must be sent after any SCPI command that changes a PIM Master related measurement parameter. This command is required to update the PIM Master configuration.

Copyright 2010, 2011 Anritsu Company
	Anritsu Company
	1-800-ANRITSU
	10450-00027, Rev. B
	mmdtechpubs@anritsu.com