Programming Commands

­SCPI Commands

:CONFigure Subsystem

:CONFigure:PIManalyzer:SETup

:INITiate Subsystem

:INITiate:PIManalyzer:MEASure NOISe|PIM

:SENSe Subsystem

:[SENSe:]PIManalyzer:OUTput:POWer:[SENSe:]PIManalyzer:OUTput:POWer?

:[SENSe:]PIManalyzer:TESt:DURation:[SENSe:]PIManalyzer:TESt:DURation?

:[SENSe:]PIManalyzer:FREQuency:F1|F2:[SENSe:]PIManalyzer:FREQuency:F1|F2?

:[SENSe:]PIManalyzer:AUTorange OFF|ON|0|1:[SENSe:]PIManalyzer:AUTorange?

:[SENSe:]PIManalyzer:MEASure:VALue?

:[SENSe:]PIManalyzer:MEASure:STATus?

:[SENSe:]PIManalyzer:IMD:ORDer:[SENSe:]PIManalyzer:IMD:ORDer?

Warning

The Anritsu PIM Master is capable of producing up to 100 Watts of RF power in the cellular communications bands. Users must take precautions to minimize exposure to these RF fields: Always terminate the output port of the test equipment into a load, a loaded line or a line that will radiate or absorb the energy before beginning a PIM test. Confirm that the PIM Master RF power is off after a PIM test. Always confirm that the RF power is off before disconnecting a coaxial connection, otherwise RF burns may result. Immediate burns to fingers or eyes can result from exposure to live connectors. RF power can be immediately turned off with the Emergency Stop button (Figure: PIM Master MW8219A Connector Panel). Ensure all antenna’s under test are placed so that no personnel are exposed to RF levels that exceed the maximum allowable exposure.

Copyright 2010, 2011 Anritsu Company
	Anritsu Company
	1-800-ANRITSU
	10450-00027, Rev. B
	mmdtechpubs@anritsu.com