Power Meter Measurement Guide : Power Meter : Freq (Frequency) Menu
 
Freq (Frequency) Menu
Key Sequence: Frequency  
Note 
Refer to Frequency Menu with Offset Function if your instrument firmware supports frequency offset (bottom submenu is Step Size & Offset).
Power Meter Freq Menu
Center Freq
Sets the frequency at the center of the measurement. Frequencies can be entered in units of GHz, MHz, kHz, or Hz. Enter the frequency by using the keypad, the rotary knob, or the arrow keys. When the center frequency is entered, the labeling below the analog display shows the center frequency and the span in the most appropriate units based upon the value.
Start Freq
Enter a start frequency by using the keypad, the rotary knob, or the arrow keys. If the entered start frequency is greater than the current stop frequency, then the stop frequency is automatically adjusted to be 1 kHz greater than the start frequency (Min Span).
Stop Freq
Enter a stop frequency by using the keypad, the rotary knob, or the arrow keys. If the entered stop frequency is lower than the current start frequency, then the start frequency is automatically adjusted to be 1 kHz less than the stop frequency (Min Span).
Span
Opens the Span Menu.
Freq Step
Sets the interval that is used by the arrow keys. Enter the step amount by using the keypad, the rotary knob, or the arrow keys.
Signal Standard
Opens the signal standard menu, showing the currently selected signal standard and a complete list of signal standards to choose from.
Channel
Sets the channel information for the selected standard. If the particular standard has not been used before, then the channel number defaults to the lowest legal channel number for that standard. If that standard has been used before, then the last used channel will be the default.
Full Band
Sets the frequency of the unit to a 100 MHz span on the current center frequency.