Spectrum Analyzer Measurement Guide : Interference Analyzer (Option 25) : Span Menu
 
Span Menu
Press the Span submenu key to access the Span menu, which is used to set the frequency range over which the instrument will sweep. The span can be set from 10 Hz to the maximum frequency of the instrument. The Span can also be set to zero span.
Key Sequence: Freq > Span 
IA Span Menu
Span
This submenu key shows the current value for span in units of GHz, MHz, kHz, or Hz. When the Span button is pressed, span becomes the active parameter and may be changed. Use the keypad, the directional arrow keys, or the rotary knob to increase or decrease the span frequency. If the span is changed by using the up and down arrow keys, the span changes by the value of the Frequency Step entered in the Freq (Frequency) Menu.
Span Up 1‑2‑5
This is a convenient way to quickly arrive at a wider span value. The first time the submenu key is pressed, the span value increases to the nearest even value that starts with 1, 2, or 5. For example if the span is 1.8 MHz, pressing the submenu key for the first time changes the span to 2.0 MHz, the next press takes the value to 5.0 MHz and so on.
Span Down 1‑2‑5
This is a convenient way to narrow the frequency span. The first time the submenu key is pressed, the span value decreases to the nearest even value that starts with 1, 2, or 5. For example if the span is 1.8 MHz, pressing the submenu key for the first time changes the span to 1.0 MHz, the next press takes the value to 500 kHz, then 200 kHz and so on.
Full Span
Pressing this button sets the span to cover the entire frequency range of the instrument.
Zero Span
This submenu key sets zero span. In this mode the display shows amplitude changes at a single frequency. This function is frequently used to allow the easy monitoring of power variations over time. For example, if information about the amplitude of an 802.11a access point signal is needed, the access point frequency would be set as the center frequency, resolution bandwidth would be set to a value wide enough to encompass as much of the signal as possible and the tester would walk around the access point usable area while the instrument records the amplitude using slow sweep.
Zero Span (Option 89)
If Option 89 is installed on your instrument, press the Zero Span key again (after the circle is red) to access the Zero Span IF BW Menu (Option 89).
Last Span
This submenu key returns the span to the most recent span value immediately before a change was made.
Back
Returns to the previous menu.