VNA Master™ User Guide Model MS20xxC Vector Network Analyzer with Spectrum Analyzer : General Information : Soft Carrying Case and Tilt Bail
 
Soft Carrying Case and Tilt Bail
The soft carrying cases for the MS202xC and the MS203xC accommodate the different instrument sizes. The part numbers are in the Technical Data Sheet. The tilt bail is factory‑installed on the VNA Master for use with or without the soft carrying case.
VNA Master Soft Carrying Case
The MS20xxC can be operated while in the soft carrying case. On the back of the case is a large storage pouch for accessories and supplies.
To install the MS20xxC into the soft carrying case, perform the following:
1. The front panel of the case is secured with hook and loop fasteners. Fully open the front panel of the case.
2. Place the soft carrying case face down on a stable surface, with the front panel fully open and laying flat.
3. Fully open the zippered back of the case.
Note 
Two zippers are located around the back of the case. The zipper closer to the MS20xxC compartment of the case opens the case back and allows access to install and remove the MS20xxC. The other zipper closer to the back of the case opens a support panel that can be used to provide support for improved stability and air flow while in the case. This support panel also contains the storage pouch.
4. Insert the MS20xxC face down into the case, taking care that the connectors are properly situated in the case top opening. Figure: Instrument Inserted Into the Soft Carrying Case shows the MS20xxC in the case.
Instrument Inserted Into the Soft Carrying Case
5. Close the back panel and secure it with the zipper .
VNA Master Installed in Soft Case
The soft carrying case includes a detachable shoulder strap that can be connected to the D‑rings on the upper corners of the case as required for comfort or convenience. The velcro strap acts as a tilt bail when using the soft case as shown in Figure: VNA Master Installed in Soft Case.
VNA Master Tilt Bail Stand
The supplied Tilt Bail can be used for desktop operation. The tilt bail provides a backward tilt for improved stability and air flow. Refer to Figure: Tilt Bail Extended on VNA Master.
To deploy the tilt bail, pull the bottom of the tilt bail away from the back of the unit.
Tilt Bail Extended on VNA Master
To store the tilt bail, push the bottom of the bail toward the back of the unit and snap the bottom of the bail into the clip on the back of the unit.