Saving Measurements

1.	Press Shift then File (7).

2.	Press the Save Measurement submenu key.

3.	Use the submenu keys and number keypad to enter a filename.

4.	Press the Change Save Location submenu key and set the current location to be the USB flash drive or internal memory, and then press Set Location.

5.	Press Change Type (Setup/JPG/…) if you decide to save Limit Lines or the setup.

6.	Press Enter to save.

You can also press the Save submenu key and use the Change Type submenu key to select Measurement.

Refer to File Management for additional information. File management in ISDB‑T SFN mode differs from all other modes (refer to File Management — ISDB‑T SFN).

Copyright 2011 Anritsu Company
	Anritsu Company
	1800-ANRITSU
	10450-00034, Rev. A
	mmdtechpubs@anritsu.com