Mobile WiMAX Signal Analyzer

Introduction

Instrument Options for Mobile WiMAX

Mobile WiMAX Measurements

General Measurement Setups

Bandwidth Setup

Frame Length Setup

Demod Type Setup

Span Setup

Mobile WiMAX RF Measurements

Setup for RF Measurements

Spectrum

Power versus Time

Adjacent Channel Power Ratio (ACPR)

RF Summary

Mobile WiMAX Demodulator Measurements

Setup for Demodulator Measurements

Constellation

Spectral Flatness

EVM versus Sub Carrier

EVM versus Symbol

Modulation Summary

DL‑MAP

Mobile WiMAX Over the Air (OTA) Measurements

Setup for Measurements Setup

Channel Power Monitor

Preamble Scanner

Pass / Fail Mode

WiMAX Summary

Mobile WiMAX Menus

Freq (Frequency) Menu

Amplitude Menu

Setup Menu

Setup (2) Menu

Measurements Menu

RF Measurements Menu

Demodulator Menu

Demodulator Menu (Continued)

Over-The Air Menu

Pass Fail Mode Menu

Marker Menu

Sweep Menu

Measure Menu

Trace Menu

Limit Menu

Other Menus

Introduction

The instrument offers three Mobile WiMAX options for testing WiMAX BTS transmitter performance: Over‑the‑Air (OTA), RF, and Demodulator Measurements. OTA Measurements require that an antenna be attached to the Spectrum Analyzer RF In (50 Ohm) connector on the instrument. Attach a coupler or attenuator to the same connector to make measurements directly from the WiMAX BTS transmitter.

Caution

The maximum (without damage) input level of the RF In port is + 30 dBm. To prevent damage, always use a coupler or a high power attenuator.

Instrument Options for Mobile WiMAX

Mobile WiMAX Over‑the‑Air (OTA) Measurements (Option 37)

Mobile WiMAX RF Measurements (Option 66)

Mobile WiMAX Demodulator (Option 67)

 

 

Copyright 2011 Anritsu Company
	Anritsu Company
	1800-ANRITSU
	10450-00034, Rev. A
	mmdtechpubs@anritsu.com