Connect the input signal or antenna to the RF In connector on the top of the instrument. For connector descriptions, refer to Connector Panel.
Editing and Entering Values
• Parameter values that are ready for editing are displayed in red on the submenu key. After changing the value, press Enter to set the new value.
• Some submenu keys have toggled parameter values (On / Off, Low / High, On/Large/Off). On these submenu keys, the current value is underlined. Press the submenu key to toggle the value.
• Use the Arrow keys, numeric keypad, or rotary knob to change submenu key values or to select list box options.
Selecting the Analyzer Mode
The instrument Analyzer Modes are also referred to as Measurement Modes or Applications. To switch to a different mode:
1. Press the Menu button on the instrument front panel.
2. Press the desired screen icon. Refer to Menu Key.
Alternatively, you can:
1. Press Shift followed by the Mode (9) key on the numeric keypad to display the Mode Selector list of installed applications (refer to Mode Selector).
2. Use the directional Arrow keys or the rotary knob to highlight the desired mode. The left and right Arrow keys skip to the top and bottom of the list, respectively.
3. Press Enter.
To exit without changing the selection, press Esc.