 | Calibration Start Calibration Press this submenu key and follow the instructions on screen. Measure Press this submenu key to start the calibration process.  Cal Setup Press this submenu key to open the Setup window to allow adjustments to the Cal Type, Cal Line, Port DUT, and Port Cal Kit. Refer to Figure: Cal Setup Window Showing Cal Type Selection Table. Thru Update Opens the Calibration dialog box to allow calibrating the Thru component without repeating the entire calibration sequence. This key is displayed only after a calibration with a Thru component. Cal Info ... Press this submenu key to display information about the current settings and active cal settings. Refer to Figure: Cal Info Window. Interpolation On Off Press this submenu key to toggle Interpolation On or Off. After performing a calibration, you can turn Interpolation On and then change the frequency range (smaller) or change the number of data points (to be higher than 1033). Cal Correction On Off Pressing this submenu key determines whether the active cal is applied to the current measurement. |