SCPI commands can be sent to the instrument through any Virtual Instrument Software Architecture (VISA) controller. VISA is a commonly used API in the Test and Measurement industry for communicating with instruments from a PC. The physical connection between the PC and the instrument is USB or Ethernet. NI-VISA is the National Instruments implementation of the VISA I/O standard. Information and downloads are available at: http://www.ni.com/visa/
The following examples describe the verification that a VISA controller can interact with the instrument. The images shown and the instructions for your instrument and software may differ from the examples.
Note
Before remote operation, confirm that the instrument is not in the Menu screen. Sending commands while the Menu screen is displayed is an invalid operation. See your User Guide regarding the Menu screen.
VISA Interactive Control
1. On the PC, run VISA Interactive Control and double-click on the instrument.
VISA Interactive Control
2. Select the viWrite tab and execute the default *IDN? write by clicking the Execute button.
VISA Interactive Control viWrite Tab
3. Select the viRead tab and click the Execute button. If the PC is connected to the instrument the command returns the following information from the Buffer: manufacturer name (“Anritsu”), model number/options, serial number, and firmware package number.
VISA Interactive Control viRead Tab
USB Connectivity
1. On the PC, run NI Measurement & Automation Explorer or VISA Interactive Control and double-click on the TMC Class instrument.
Figure 1-4. NI Measurement & Automation Explorer
2. Verify that the USB Settings list the correct Manufacturer, Model, and Serial Number, as shown in the example below.
NI VISA Interactive Control USB Configurations / Settings Tab.
3. Select the Input/Output, Basic I/O tab and execute the default *IDN? Query. If the PC is connected to the instrument, then the command returns the following information from the Buffer: manufacturer name (“Anritsu”), model number/options, serial number, and firmware package number, as shown in the example below.
NI VISA Interactive Control USB Basic I/O Tab.
Ethernet Connectivity
1. On the PC, run NI Measurement & Automation Explorer or VISA Interactive Control and create a new LAN Resource under Network Devices. Add the TCP/IP resource using a Manual Entry of Raw Socket, as shown in the example below.
NI VISA Interactive Control LAN resource addition using Raw Socket.
2. Enter the IP address that the instrument has acquired (go to System (9), Status). Enter the port number as 9001, as shown in the example below.
NI VISA Interactive Control LAN resource settings of IP address and port number.
NI VISA Interactive Control LAN resource validated.
3. Select the Configuration I/O settings tab and verify that the Termination Methods are set as shown in the example below.
NI VISA Interactive Control LAN resource I/O Termination Method Settings
4. Select the Input/Output Basic I/O tab and execute the default *IDN? Query. If the PC is connected to the instrument, then the command returns the following information from the Buffer: manufacturer name (“Anritsu”), model number/options, serial number, and firmware package number, as shown in the example below.
NI VISA Interactive Control USB Basic I/O Tab.
Note
When sending SCPI commands over Ethernet, you are required to send a newline termination character at the end of each command. In the example above, a newline character ("\n" in this case, but could be different depending on your programming environment) was used to terminate the *IDN? command.
When sending query commands over raw socket, the entire buffer must be read before the next query command is sent. Each query result is terminated by a newline to help identify the end of the query response. Query read operations could be broken into multiple reads, if necessary.
When using raw socket connections, you must close a session before opening a new one or before switching to a new protocol (such as USB). If you try to open a new session or switch protocols without first closing the previously opened session, then you may lose communications with the instrument and may not be able to reconnect until you reboot the instrument.
