This section describes how to set up the Cable and Antenna parameters, markers, and limit lines. Instructions are based on the assumption you are using a tablet to control and operate the Site Master.
Frequency
1. Press Freq/Dist, then press Frequency if the menu is collapsed.
2. Press the Start Frequency submenu key and use the virtual keypad to enter the value in the edit box. See Figure: Entering Frequency Setting.
3. Press one of the unit keys (GHz, MHz, kHz, or Hz) to apply the new value and close the edit box.
To exit without making a change, press Esc to cancel the entry, and Esc again to close the edit box.
Entering Frequency Setting
4. Press the Stop Frequency submenu key and use the keypad to enter the value in the edit box, then press one of the unit keys to apply.
