Table: Parameter And Data Entry Commands lists the command mnemonic codes that open parameters for data entry. The commands listed open a parameter for data entry. Once opened, a parameter remains open until another parameter is opened.
Data Entry
When a parameter is open for data entry, its value can be changed as follows:
• By sending a numeric value followed by the appropriate terminator code
• By incrementing or decrementing its value using an associated step size
Note
An appropriate data terminator must be used to terminate a numeric-parameter entry, and it must immediately follow the numeric value. If it does not, a parameter entry error will result.
The parameter and data entry commands do not affect the signal generator’s output unless the parameter being changed is also the current output parameter. The commands, therefore, may be used to change the preset values of parameters without altering the MG362x1A output.
Parameter And Data Entry Commands
Mnemonic Code
Parameter
Values
Units
F1
Opens the F1 parameter.
Resets the MG362x1A to its default settings.
GH, MH, KH, HZ
LOS
Opens the level offset parameter.
+100dB to 100dB (logarithmic); +xxx mV to xxx mV (linear)