Rubidiumâ„¢ MG362x1A SeriesLow-Noise RF/Microwave SignalGenerators : Instrument Operation : Frequency Step Sweep Operation : Step Sweep SETUP Menu
 
Step Sweep SETUP Menu
Pressing STEP from the SWEEP menu displays the SETUP menu. When the STEP SWEEP button is toggled on, the status bar displays Step Sweep - Single. Note that the sweep displayed at the status bar is dependent on the sweep selected in the TRIGGER menu. The sweep displayed at the status bar is dependent on the sweep selected from the SUMAMARY menu or from the TRIGGER menu. See TRIGGER Menu.
Press: SWEEP | STEP | SETUP
Step Sweep SETUP Menu
START
Set the start frequency of the step sweep. Range is 9 kHz to 43.5 Hz.
STOP
Set the stop frequency of the step sweep. Range is 9000.001 Hz to 43.5 GHz.
STEP SIZE
Set the step size of the step sweep. Range is 0.001 Hz to 43.5 Hz.
NUMBER OF POINTS
Set the number of points in a step sweep. Range is 2 to 65535.
DWELL TIME
Sets the sweep per point dwell time. Units are in seconds. Range is 1e-05 s to 99 s
SWEEP DIRECTION
Sets the direction of the sweep up/down. Up = start to stop sweep. Down = stop to start sweep.
PRESET SWEEP RANGES
Selects a frequency sweep range preset.
Range: F1F2|F3F4|F5DF|F6DF
SWEEP TYPE
Sets the parameter for sweep type to Logarithmic or Linear sweep operation.
STEP SWEEP
Toggle step sweep on or off.