BTS Master MT8221B and MT8222B : Basic Measurement Setups
  
Basic Measurement Setups
 
Introduction
Measurement Setup
Connect the Input Source
Editing and Entering Values
Selecting the Analyzer Mode
Set the Measurement Frequency
Using Start and Stop Frequencies
Entering Center Frequency
Selecting Signal Standard
Setting Measurement Frequency Bandwidth
Set the Amplitude
Setting Amplitude Reference Level and Scale
Setting Amplitude Range and Scale
Power Offset Set Up for Compensating External Loss
Set the Span
Setting Up Limit Lines
Single Limit Line
Segmented Limit Lines
Limit Line Envelope
Setting Up Markers
Selecting, Activating, and Placing a Marker
Selecting, Activating, and Placing a Delta Marker:
Viewing Marker Data in a Table Format
Introduction
This chapter provides a brief overview of the Anritsu MT8221B BTS Master. The intent of this chapter is to provide a starting point for making basic measurement setups. This chapter describes setup, configure frequency, bandwidth, and amplitude before configuring your measurement setups. After measurements are taken, refer to section Managing Files for a description of saving, recalling, and deleting measurement files. For more detailed information about specific measurements, refer to the measurement descriptions in the measurement guides for the specific instrument mode and analyzer technology (such as WiMAX or 3GPP). Refer to Measurement Guides, for a list of these guides and their Anritsu part numbers.