Cell Master User Guide : Quick Start Guide
 
Quick Start Guide
 
Introduction
Measurement Mode Selection
Cable & Antenna Analyzer
Select the Measurement Type
Set the Frequency
Set the Amplitude
Turn on Markers
Single Limit Line
DTF Setup
Calibrate with OSL Calibration
Spectrum Analyzer
Set Start and Stop Frequencies
Enter the Center Frequency
Select a Signal Standard
Set the Measurement Frequency Bandwidth
Set the Amplitude
Power Offset Set Up for Compensating External Loss
Set the Span
Single Limit Line
Create a Limit Envelope
Setting Up Markers
Select a Measurement Type
External Power On
Introduction
This chapter provides a brief overview of basic setups for the following measurement modes:
• Cable & Antenna Analyzer
• Spectrum Analyzer
For detailed descriptions of measurement functions and settings, refer to the appropriate Measurement Guide as listed in Measurement Guides.