PIM Master™ Passive Intermodulation Analyzer : Swept PIM : Swept PIM Setup
  
Swept PIM Setup
Note 
In most cases, information and parameters can be entered through the keypad or the directional Arrow keys. The number keypad enters the information directly. The Up and Down arrow keys change a frequency parameter by 1 MHz. The Left and Right arrow keys change the frequency parameter by 10 MHz. Choose whichever method is most convenient to enter the required information.
1. Turn on power to the PIM Master.
2. Select the PIM Analyzer mode. Refer to Mode Selector Menu.
3. Select the Swept PIM measurement from the Measurements menu (refer to Measurements Menu).
4. Connect the test port cable between the test port connector of the PIM Master to the device under test (DUT).
Warning 
Confirm that connections are secure. High power RF signals are emitted from the test port and can cause bodily injury. Anritsu recommends using a torque wrench for this connection.
This device (DUT) may be the main feeder cable from the tower or a simple jumper cable. The DUT must be connected to a termination device, such as a low PIM termination or an Antenna.
Caution 
Do not use a precision load as the termination device because they are not designed to handle the power of the PIM Master and will become damaged immediately.