S820E Microwave Site Masterâ„¢ User Guide : Cable and Antenna Measurements : Sweep Trigger Menu
 
Sweep Trigger Menu
Key Sequence: Sweep (3) > Sweep Trigger
Sweep Trigger Menu
Sweep Trigger
Continuous
Sets the sweep trigger to internal and continuous, and sets the Run/Hold setting to Run. A new sweep is triggered automatically at the end of each sweep. This is the default sweep trigger setting.
Single
Sets the sweep trigger to internal and single, and sets the Run/Hold setting to Hold. Each sweep is activated by the Run/Hold submenu key.
Ext. Trigger
Sets the sweep trigger to an external source. Each sweep is activated by a TTL signal at the External Trigger In connector. Refer to Test Panel Connector Overview.