The Sensor Settings submenu under the Display main menu adjusts the inline sensor parameters (Figure: Sensor Settings). The on screen instructions provide information for each parameter. To change a parameter, select it with the Up/DownArrow keys or the touchscreen and press Edit.
Note
Several sensor settings are only appropriate for specific measurements. Refer to the on screen information in the Sensor Settings dialog for additional information.
Sensor Settings
Modulation
In the Sensor Settings dialog, highlight the Modulation = ... row and press Edit. Use the Up/Down keys, rotary knob or touchscreen to highlight the desired modulation type, and then press Select.
Sensor Settings
The selection of a specific modulation type provides a correction factor to refine the PEP calculation.
Duty Cycle
Sets the duty cycle used for averaging when the forward measurement is set to Burst Average Manual. Select a value from 0 % to 100 %. In the Sensor Settings dialog, highlight the Duty Cycle = ... row and press Edit. Use the Up/Down keys, rotary knob or key pad to set the duty cycle and then press Enter.
Video Bandwidth
Sets the Video Bandwidth span used in several forward measurements. In the Sensor Settings dialog, highlight the Video BW = ... row and press Edit. Use the Up/Down keys, rotary knob or touchscreen to highlight the desired View BW and then press Select.
CCDF Threshold
Sets the power threshold value used in the Complementary Cumulative Distribution Function (CCDF) forward measurement. CCDF describes the probability that the signal power is greater than the user‑defined threshold value. In the Sensor Settings dialog, highlight the CCDF Threshold ... row and press Edit. Set the desired value and press one of the units of measure buttons to complete.