 | Scanner: Press this submenu key to display the Sync Signal (S‑SS) Power table. Press it again to display the OTA Scanner Menu to set up Sort By and Show Mod Results. Tx Test: Opens the OTA Tx Test mode. Press it again to open the Over‑the‑Air Tx Test Menu and the Show Mod Results submenu key. Mapping: Sets the display for coverage mapping. Press it again to set the coverage mapping parameters – Save/Recall Points/Map, Measurement Setup and Point Distance/Time Setup. For full details, refer to LTE and TD‑LTE Coverage Mapping. Carrier Aggregation: Press this submenu key to display the Carrier Aggregation Component Carrier frequencies and measured parameters. In the Carrier Aggregation Menu, select the desired Component Carrier to set up for measurement. Refer to Carrier Aggregation Menu. EMF (Option 444 only): When first selected, this submenu key enables the EMF Measurement mode. Once the EMF Measurement mode is active, this button opens the LTE/TD-LTE EMF Menu. Back: Press this submenu key to return to the Measurements Menu. |