 | Meas Mode Press this submenu key to open the Select Meas Mode list box. Scroll through the list to select the desired Measurement Mode: Single, Continuous, Average, Moving Average, and Max Hold. Refer to Meas Mode Settings. Bit Count Setting Press this submenu key to open the Bit Count Setting Editor and the BER Bit Count Setting Menu (Option 57 Only). Use the Mantissa or Exponent submenu key to select between these parameters for editing. Enter the desired mantissa and exponent. The mantissa value ranges from 1 to 9, and the exponent value ranges from 6 to 12. Resolution for each is 1. Service Press this submenu key to open the Select Service list box. Scroll to select In Service or Out of Service. Refer to Service. Stream Press this submenu key to open the Select Stream list box. Scroll to select between high priority (HP) or low priority (LP) signal stream. BER Meas Point This submenu key is displayed only when the Service submenu key is set to Out of Service. Press this submenu key to open the Select BER Meas Point dialog box. Select the desired view of the measurement taken. Refer to BER Measurement Point. This submenu key is displayed only when Out of Service is selected. Refer to Service. Result Disp Current Last Press this submenu key to toggle the displayed result, choosing either to view the Current measurement or to view the Last measurement taken. The Current measurement display is periodically updated. More Press this submenu key to open the BER Setup (2/2) Menu (Option 57 Only). |