VNA Master™Programming Manual : Vector Voltmeter Commands
 
Vector Voltmeter Commands
 
Introduction
Vector Voltmeter Commands
VVM Commands
:MMEMory Subsystem
:MMEMory:LOAD Subsystem
Recall Setup
Recall Measurement
:MMEMory:STORe Subsystem
Save Setup
Save Measurement
:TRACe VVM Subsystem
Trace Header Transfer
Trace Header Parameters
[:SENSe]:SWEep Subsystem
IF Bandwidth
[:SENSe]:VVM Subsystem
Return Measurement Format
Measurement Mode
Measurement Type
[:SENSe:]:VVM:CABLe Subsystem
Cable
[:SENSe]:VVM:FREQuency Subsystem
CW Frequency
[:SENSe:]:VVM:REFerence Subsystem
Clear Reference
Set Reference
:FETCh:VVM Subsystem
Data
FETCh:VVM:REFerence Subsystem
Reference Data
Introduction
This chapter describes commands for Vector Voltmeter mode. Only the commands that are listed in this chapter and in All Mode Commands can be used in Vector Voltmeter mode. Using commands from other modes may produce unexpected results.
Notational conventions are described in Command and Query Notational Conventions.