VectorStar™ MS4640A SeriesMicrowave Vector Network Analyzer : SCPI Commands : :SENSe{1-16}:CORRection:INTerpolate Subsystem
 
:SENSe{1-16}:CORRection:INTerpolate Subsystem
The :SENSe{1-16}:CORRection:INTerpolate subsystem command controls the interpolation state of RF calibration.
Calibration Setup Subsystems
These subsystems are used during various phases of calibration configuration setup:
• :CALCulate{1-16}:IMPedance:TRANsformation Subsystem
• :CALCulate{1-16}:REFerence Subsystem
• :SENSe{1-16}:CORRection:COLLect:METHod Subsystem
• :SENSe{1-16}:CORRection:COLLect:MICrostrip Subsystem
• :SENSe{1-16}:CORRection:COLLect:MULTIple Subsystem
• :SENSe{1-16}:CORRection:COLLect Subsystem
• :SENSe{1-16}:CORRection:COLLect:WAVeguide Subsystem
• :SENSe{1-16}:CORRection:COLLect[:CALa]:PORT Subsystem
• :SENSe{1-16}:CORRection:INTerpolate Subsystem
• :SENSe{1-16}:CORRection:ISOLation Subsystem
• :SENSe{1-16}:CORRection:STATe Subsystem
 
:SENSe{1-16}:CORRection:INTerpolate:STATe <char1>
:SENSe{1-16}:CORRection:INTerpolate:STATe?
Description
The command Turns RF interpolation on/off for the indicated Channel.
The Query outputs the RF interpolation on/off status of the indicated Channel.
Cmd Parameters
<char1> 1 | 0 | ON | OFF
Query Parameters
NA
Range
NA
Default Value
0
Syntax Example
:SENS1:CORR:INT:STAT ON
:SENS1:CORR:INT:STAT?