T1/T3 Analyzer (Option 53) 

Introduction

Selecting the T1/T3 Analyzer Mode

T1 Fundamentals

Signal Setup

T1 Configuration Menu

Signal Setup

T3 Fundamentals

M13 Framing

C‑bit Framing

Far-End Block Error (FEBE) Function

T3 Display

T3 Configuration Screen

T3 Pattern/Loop Menu

T3 Error/Alarm Menu

T3 Measurement Screen

BERT Histogram Display

Start/Stop Key

T3 Menus

T3 Configuration Menu

Signal Setup

Payload Setup

T3 Pattern/Loop Menu

Payload is 45MB

Payload is less than 45MB

Select Loop Codes Menu

T3 Error/Alarm Menu

Error Ins Menu

Alarm Ins Menu

T3 Measurements Menu

BERT Menu

Histogram Menu

VF Menu

Calibrate Menu

Sweep Menu

Measure Menu

Trace Menu

Limit Menu

Other Menus

T3 In‑service Testing

Required Equipment

Measurement Setup Procedure

Rx Signal Measurement Procedure

T3 Out‑of‑service Measurements

Required Equipment

BERT Measurement Setup Procedure

Basic BERT Measurement Procedure

Quick Check

Histogram Display

To Insert Errors/Alarms

Event List

Rx Signal Measurement Procedure

VF Channel Access Testing

AUTO Signal Setup Explanation

Introduction

This chapter provides a brief description of T3 circuits as well as T3 measurements, and also explains how to measure T3 performance using the instrument with Option 53 installed.

“T1/FT1 Analyzer (Option 51 or 54)” describe T1 technology and testing, and this chapter describes T3 technology and testing.

Copyright 2010 Anritsu Company
	Anritsu Company
	1-800-ANRITSU
	10450-00024, Rev. B
	mmdtechpubs@anritsu.com