Quick Start Guide

LMR Master™S412E User Guide : Quick Start Guide

Quick Start Guide

Measurement Mode Selection

CW Signal Generator

Vector Network Analyzer

Field Mode Display vs. Standard VNA Display

Select the Measurement Type

Set the Frequency

Turn On Markers

Peak and Valley Search Markers

Set Up Delta Markers

Set a Single Limit Line

Set Up Distance Domain

Calibration Considerations

Spectrum Analyzer

Set Start and Stop Frequencies

Enter the Center Frequency

Select a Signal Standard

Set the Measurement Bandwidth

Set the Amplitude

Power Offset Set Up for Compensating External Loss

Single Limit Line

Create a Limit Envelope

Setting Up Markers

Select a Smart Measurement Type

Set the Receiver (Rx) Frequency

Set the Signal Source Transmit (Tx) Frequency

Rx and Tx Power Offset

Select the Measurement Types

LMR Digital Demodulation Signal Analyzers

Set the Receiver (Rx) Frequency

Set the Signal Source Transmit (Tx) Frequency

Rx and Tx Power Offset

Select the Measurement Types

Saving Measurements

External Power On

Introduction

This chapter provides a brief overview of basic measurement setups for several measurement modes. For detailed measurement information, refer to a specific measurement guide listed in Measurement Guides. This chapter provides quick start measurement information for the following measurement modes:

• CW Signal Generator

• Vector Network Analyzer

• Spectrum Analyzer

• NBFM Analyzer

• LMR Digital Demodulation Signal Analyzers

Note	LMR Digital Demodulation Signal Analyzers include P25/P25p2, NXDN™, dPMR, DMR, PTC-ITCR, PTC-ACSES, and TETRA Signal Analyzers.