VectorStar™ MS464xB Series Microwave Vector Network Analyzer User Interface Reference : Display Menus : Display Main Menu
 
Display Main Menu
DISPLAY Menu
Previous
• MAIN Menu
Navigation
• MAIN | Display | DISPLAY
 
DISPLAY Menu 
1. DISPLAY menu with frequency-based sweeps at left.
2. DISPLAY menu with power-based sweeps at right.
3. Resistive Term Field Toolbar in Ohms.
4. Reactive Term (j) Field Toolbar in Ohms.
Display Menu Note (when Spectrum Analysis is active)
When the Spectrum Analysis application is active, the following DISPLAY menu buttons are disabled:
Domain, Conversion, Resistive Term, and Reactive.
When the pointer is placed over a menu item, a tool tip noting “Not available in Spectrum Analysis” will appear.
Trace Format
Displays the current trace format setting. Select displays the TRACE FORMAT menu.
• TRACE FORMAT Menu
View Trace
Select displays the VIEW TRACE menu.
• VIEW TRACE Menu
Trace Limit Lines
Select displays the LIMIT menu.
• LIMIT Menu
Domain
Select displays the DOMAIN menu. The appearance and button availability of the DOMAIN menu depends on settings on other menus.
• DOMAIN Menu
Note 
Domain button functionality is disabled when IMDView or Spectrum Analysis are enabled.
Gain Compression
The Gain Compression button is available if the SWEEP TYPES menu is set to Power (CW Freq) or Power (Swept Freq). Different menus are presented depending on which power sweep mode is used. If available, select displays the GAIN COMPRESS. menu.
• GAIN COMPRESS. Self Normalization Menu
• GAIN COMPRESS. Compression Param Menu
The Gain Compression button is unavailable if the SWEEP TYPES menu is set to:
• Freq Sweep (Linear)
• Freq Sweep (Log)
• Segmented Sweep (Freq-Based)
• Segmented Sweep (Index-based)
• SWEEP SETUP Menu
• MAIN | Sweep Setup | SWEEP SETUP | Sweep Types | SWEEP TYPES
Inter-trace Math
Select displays the INTERTRACE MATH menu.
• INTER-TRACE MATH Menu
Conversion
Select displays the CONVERSION menu.
• CONVERSION Menu
Resistive Term (Ohms)
Select allows the user to enter the trace impedance in Ohms and displays the Resistive Term toolbar. Use the toolbar to enter the required impedance for the currently active trace. The default value is 50.000 Ohms.
Reactive (j) (Ohms)
Select allows the user to enter trace reactive term in Ohms and displays the Reactive (j) toolbar.
Display Area Setup
Select displays the menu.
• DISPLAY SETUP Menu