Land Mobile Radio Analyzer and Coverage Measurement Guide : TETRA Analyzer (Option 581)
 
TETRA Analyzer (Option 581)
 
Introduction
Over the Air (OTA) Analysis Setup
Using the Signal Generator for Receiver or OTA Analysis
TETRA Analyzer Graphs
Constellation
Spectrum Graph
Eye Diagram
Summary and TETRA Summary Graphs
TETRA IQ Data
TETRA Base Station Receiver Sensitivity Testing
Airbus TB3 TETRA Station (Single Rx/Tx Port)
Airbus TB3 TETRA Station (Separate Rx/Tx Ports)
Hytera TETRA Station
Motorola TETRA Station
ETELM TETRA Station
TETRA Analyzer Menus
Frequency Menu
Amplitude Menu
Vertical Scale Menu
Setup Menu
Setup (2/2) Menu
Measurement Menu
Display Menu
BS Sensitivity Menu
Sweep Menu
Measure Menu
Trace Menu
Limit Menu
Other Menus
Introduction
The TETRA Analyzer option provides a method to verify the operation of TETRA repeater transmitters. Option 581 includes the ability to display constellation, spectrum, histogram, and eye diagram graphs. In addition, a summary graph displays numeric values of received power, frequency error, error vector magnitude (EVM), IQ imbalance, phase and magnitude errors, and symbol rate error of the input signal. The analyzer also reports the base station extended color code (BS ECC), mobile color code (Mobile CC), mobile network code (Mobile NC), base color code (Base CC), location area code (LAC), and mobile station maximum transmit power (MS Max TX Pwr) permitted on a channel from the TETRA transmitter.
The LMR Master TETRA Analyzer and TETRA Coverage Mapping options are intended for use on over‑the‑air (OTA) signals. The LMR Master signal generator outputs CW, AM and FM signals while in the TETRA Analyzer mode.
The LMR Master will analyze input signal strengths from +33 dBm (2.0 watts) down to levels approaching the sensitivity of TETRA radios, automatically adjusting the input sensitivity based on input levels.